Oce TDS600 User Manual page 35

Prepare the reinforcement knives for cleaning
Press the on line button on the printer operating panel to put the printer off line.
1
The message 'Off line' is displayed in the status window.
Press the left selection button to shift the focus to the Folding menu.
2
A shadow effect is used to indicate that the focus is set to this menu.
Select the Special option from the Folding menu.
3
Press the right selection button start activate the Knife option.
4
The following information is now displayed in the panel display:
[6] Cleaning the reinforcement knife
When a job is running, the message 'Job interrupted' appears. The
Note:
machine stops running after it has correctly finished the prints that were
already in the engine. Then the reinforcement knives are placed in the
correct position.
You can now continue to clean the reinforcement knives (see 'Maintenance of
5
the reinforcement unit' on page 254).
Use the Océ TDS600 to print 35