Oce TDS600 User Manual page 244

Specify the size and type of material on the operating panel.
14
Press the on line button again.
15
You only have to adjust the settings on the operating panel when you
Note:
alter the size and/or media type.
Roll loader
regulations as far as maximum roll weights are concerned, Océ has developed
a roll loader for use with the Océ TDS600. See 'Recommended weight limits'
on page 312 for more information about the maximum recommended roll
weights with and without a roll loader.
Use the optional roll loader to load a roll
Fully open the roll compartment.
1
Inside the drawer, the roll loaders are installed. The roll loaders consist of a
metal frame with a lever and a green knob in the middle of the lever.
Put the appropriate horizontal lever in an upright position by pulling it to the
2
right.
Pull the lever completely forward. The roll holder is lifted up (see figure 131).
3
d
[131] Lifting up the holder with the roll loader
Remove the roll holder from the paper roll compartment using both hands.
4
Press the green knob inside the roll holder to release the locking mechanism
5
and remove the core from the holder.
You can place the new roll in the groove on top of the printer.
Note:
Slide the roll holder in the new roll of material while pressing the green knob.
6
Align the roll with the appropriate size indicator on the roll holder and release
7
the locking mechanism. This line has to be completely visible.
244 Océ TDS600 Multifunctional Digital System User Manual
In order to help customers to comply with the international safety