Oce TDS600 User Manual page 163

Cut length method
Description
Min/max values
Menu path
Custom cut length
Description
Min/max values
Menu path
Add leading / trailing strip
Description
Min/max values
Menu path
Océ Power Logic: Settings Editor (for the key operator)
The Océ TDS600 determines the length and width of each
digital image. Use 'Print cut method', to select one of the fol-
lowing default cut methods:
Standard The print length corresponds to a standard format,
depending on the media width.
Synchro The print length is related to the length of the image.
This is the default value. The minimum print length is 279
mm or 11 inch.
Custom The print length is defined by the user. The minimum
length is 279 mm or 11 inch. The default value is specified
with the Cut length option.
N/A
Jobs - Copy & File - Defaults - Print card - Sheet - Cut length
method
You can define a specific cut length.
The specified cut length is used when the Custom cut method
is selected. If custom cut is enabled, the copy media length
will only depend on this setting, any other influence is exclud-
ed.
279 - 15000 mm
Jobs - Copy & File - Defaults - Print card - Sheet - Custom cut
length
Use the add leading / trailing strip settings to add, by default,
a blank strip at the top or bottom of the image. The print
length will increase accordingly.
'Add leading strip' will add a blank strip at the top of the im-
age.
'Add trailing strip' will add a blank strip at the bottom of the
image.
By default, no leading or trailing strip is defined.
Note: Adding a trailing strip will only work if the cut method
is set to synchro cut.
0 - 400 mm
Jobs - Copy & File - Defaults - Print card - Sheet - Strips - Add
leading / trailing strip
163