Table of Contents
Advertisement
config vlan 2 create byport 1
config vlan 3 create byport 1
2
To add an ATM port (in this example, 1/1) and several Ethernet ports (in this
example, 3/40 to 3/48) to the VLAN, enter:
config vlan 2 port add 1/1
config vlan 3 port add 3/40-3/48
3
To configure IP addresses on both VLANs (use two different subnets), enter:
config vlan 2 ip <ip address>/<subnet mask>
config vlan 3 ip <ip address>/<subnet mask>
4
To enable routing on both VLANs, enter:
config vlan 2 ip rip enable
config vlan 3 ip rip enable
If necessary, use the following CLI commands to change RIP parameters:
config vlan 2 ip rip <sub-command>
config ip rip <sub-command>
5
To configure an ATM 1483 PVC with LLC/SNAP-encapsulation and UBR,
enter:
config atm 1/1 pvc create 0.100 enc 1483-llc serv
ubr
6
To associate the 1483 IP routed PVC with a VLAN, enter:
config atm 1/1 pvc 1483 ip create 2 0.100 <remote
side IP address>
The remote IP address should be in the same subnet with the ATM port IP
address.
Configuring an IPX routing 1483 PVC using Device Manager
In the configuration shown in
ATM 1483 PVC as the sole member of a VLAN configured for IPX routing.
Chapter 6 Configuring the Passport 8672ATM Module
Figure
61, the Passport 8672ATM Module has an
Using the Passport 8672ATM Module
135
Advertisement
Table of Contents
