Console Mode; Syntax - Nortel Contivity1510D Reference

console mode

This is a mini-CLI command that allows emulation of CLI commands available in
earlier versions of the Contivity VPN Switch software.
This command controls which menu items are visible on the serial port console
for the switch, and what CLI commands can be used.
When this command is used to set the switch in one of the two restricted modes,
the only CLI commands that are available are:
disable
enable
exit
reload
reload at
reload in
reload no-sessions
Because none of the Global Configuration mode commands are allowed, setting
the switch into a restricted mode causes the CLI to return to Privileged Exec mode
on the Telnet session where the command is issued. Other Telnet sessions will not
be forced back to Privileged Exec mode, but they will only support the above CLI
command set.
The switch can be set back to an unrestricted mode on the System->Settings Web
management page.

Syntax

console mode {
Note: You must have a control tunnel established before you can set this
command.
restricted1|restricted2|show
Reference for the Contivity VPN Switch Command Line Interface
Chapter 2 CLI Command Summary 49
}