102 Chapter 2 CLI Command Summary
reload in
This command sets a timer that causes the switch to reboot after a certain time has
passed. Options can be specified to determine whether the switch turns off or
reboots, which configuration to use after a reboot, and other settings.
The user is prompted to confirm that they want to continue with the reload. If they
say yes and if the reload command is valid, the system reload will start at the
specified time.
Syntax
reload in [
[
boot-drive {ide0|ide1}
[
config-file
[
disable-after-restart
Parameters
[
hh|
power-off
restart
boot-safe
boot-normal
boot-drive
ide0|ide1
config-file
latest
311645-A Rev 00
:]
hh
mm [power-off|restart
{
latest|factory|config-name
mm]
The hours and minutes that must pass before the shutdown will
start. The allowed range is 00:01 to 24:00.
If present, the switch will power down after it has completed
shutdown.
If present, the switch restarts after it has completed shutdown.
If present, switch restarts in safe boot mode.
If present, switch restarts in normal boot mode.
Specify the drive from which the switch will reboot.
Disk drive from which that bootable image will be loaded.
Specify which configuration should be used after a reboot.
The switch should be rebooted with the latest configuration file.
] [
boot-safe|boot-normal
]
] [
]
text
]
}] [
disable-logins
]