Table of Contents
Advertisement
86 Chapter 2 CLI Command Summary
more
This command displays a readable file on the switch. The file is displayed on
Telnet screen at a time. The user can use the pagination keys to see the next screen
or line in the file, or to quit from the display.
It differs from the de facto standard in that it cannot be used to display a file on a
remote file system. It also does not support the /ebcdic output switch that causes
the file to be printed in EBCDIC mode.
On the switch, this command is limited to files that are 10KB or smaller. If the
user tries to use more on a file that is larger than 10KB, an error message is
displayed.
Syntax
more [/
Parameters
/ascii
/binary
file
Default
The default depends on the type of file. If the file contains non-printable
characters, it defaults to binary output, otherwise it defaults to ASCII output. You
cannot print a binary file in ASCII format output. If you attempt to print a binary
file in ASCII output format, the switch is ignored.
311645-A Rev 00
ascii|/binary
] file
Display file in ASCII.
Display file in binary.
Fully qualified name of the switch file to display. The name has
the format:
diskn:[directory/]file.ext
where: diskn is either disk0 or disk1, there are zero or more
directory names and there is a file name.
Advertisement
Table of Contents
