Nortel Contivity1510D Reference page 212

212 Chapter 3 Bulk Load Command
The ADD_RULE command allows an existing rule to be added to an existing
filter.
COMMAND: ADD_RULE
FILT_NAME: [Filter name - Required]
RULE_NAME: [Rule name - Required]
END
The CREATE_RULE command allows for the creation of a new rule definition.
COMMAND: CREATE_RULE
RULE_NAME: [Rule name - Required]
ADDR_NAME: [Address Name- Default:Any]
ACTION: [Rule action {Permit/Deny} - Default:Deny]
DIRECTION: [Direction {Inbound/Outbound} - Default:Inbound]
PROTOCOL: [Protocol Name - Default:Ip]
SRC_PORT: [Source Port Name - Default:Any]
DEST_PORT: [Destination Port Name - Default:Any]
END
The DELETE_RULE command deletes an existing rule definition. This command
will fail if the rule is being used by a filter.
COMMAND: DELETE_RULE
RULE_NAME: [
END
311645-A Rev 00
Rule name - Required
]