Host Address; Syntax; Parameters - Nortel Contivity1510D Reference

host address

This command establishes the IP address, port, bind DN, and bind password
settings for the external master and slave LDAP servers. The master server is the
primary server to process queries. If the master server becomes unavailable, the
switch attempts to use the slave LDAP servers. The switch reattempts connection
to the master server every 15 minutes or upon a configuration change. The switch
has read/write access to the master LDAP server. The slave servers are read-only.

Syntax

host address {master|slave1|slave2} [{port|ssl-port} [port_number]] [bind-dn
bind_dn_value] bind-password bind_password
no host {master|slave1|slave2}

Parameters

address
master
slave1
slave2
port
ssl-port
port_number
bind-dn
The IP address for the LDAP server. Can be a dotted IP address
or a host name. The host name does not have to be fully
qualified if it is in the same domain as the switch.
The settings for the master LDAP server
The settings for the slave 1 LDAP server
The settings are for the slave 2 LDAP server
The port number that connects to the LDAP server
The port number to connect to the LDAP server when using
SSL. In addition, the SSL encryption settings must be se.
The port number to connect to on the LDAP server
If present, the distinguished name used to connect to the LDAP
server
Reference for the Contivity VPN Switch Command Line Interface
Chapter 2 CLI Command Summary 65