Address Pools - Nortel Contivity1510D Reference

Chapter 3 Bulk Load Command 209
The MODIFY_NAT command is used to add a new rule to an existing NAT set.
COMMAND: MODIFY_NAT
NAT_NAME: [Name of existing NAT set to modify - Required]
NAT_TYPE: [Translation Type {Static/Pooled/Port} - Required]
IN_START_IP: [Internal starting IP address - Required]
IN_END_IP: [Internal ending IP address - Required]
EX_START_IP: [External starting IP address - Required]
EX_END_IP: [External ending IP address - Required for Pooled
NAT type]
END

Address pools

Two bulk load commands are used to configure address pools: CREATE_POOL
and DELETE_POOL.
The CREATE_POOL command is used to create a new address pool.
COMMAND: CREATE_POOL
NAME: [Name of new address pool]
IP_START: [Starting IP address - Required]
IP_END: [Ending IP address - Required]
MASK: [Subnet mask]
END
Reference for the Contivity VPN Switch Command Line Interface