Setting Scan Settings; Mx-4060N/Mx-4070N Only); Checking The Image To Be Transmitted - Sharp MX-3050N User Manual

Digital full colour multifunctional system

Hide thumbs Also See for MX-3050N:

Table of Contents

SCANNER/INTERNET FAX►TRANSMITTING AN IMAGE

Tap the [Greyscale] or [Mono2] key to set the B/W mode for automatic colour selection.

Specify whether Mono2 or greyscale is used when scanning black and white originals. Note that if the file format is set to

JPEG, scanning will take place in greyscale.

After the settings are completed, tap

The B/W mode can be set only when the [Auto] key is selected in the colour mode setting (step 3).

SETTING SCAN SETTINGS AUTOMATICALLY

(Auto Set) (MX-3060N/MX-3070N/MX-3560N/MX-3570N/

To automatically set scan settings appropriate for the original, tap the [Auto Set] key in the base screen of Easy Mode.

E-mail Address

The following functions are set automatically.

• Image Orientation

• Resolution

• Blank Page Skip

Each function setting value/parameter can be changed in setting mode.

When "Auto Set" is enabled, greyed out functions cannot be enabled.

To change the "Auto Set" setting, use "Settings (administrator)" - [System Settings] → [Image Send Settings] → [Scan

Settings] → [Condition Settings] → [Auto Scan Setting].

CHECKING THE IMAGE TO BE

Check the image that will be sent in the touch panel before transmission.

When you use the automatic document feeder to scan an original, you can tap the [Preview] key to check a preview of

the image before sending an image. As you can adjust the exposure and resolution to scan the original while checking it

in the preview screen, you can send a better quality original to the destination.

• Depending on the size of the transmission data, part of the preview image may not appear in the preview screen in the touch panel.

• The preview function is not available when the original size is set to Long Size.

Chapters

Table of Contents