HYOSUNG GD250 Owner's Manual page 78

⊙ BRAKE DISK INSPECTION
Check the brake disk for damage or cracks.
⊙ FRONT BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the front brake fluid reservior
around not to allow dust to get inside of it.
3. Loosen the screw and open the cap.
4. Replenish with brake fluid to the upper
line.
N O T E
The recommended brake fluid : DOT4
CAUTION
● Don't replenish with brake fluid over
the limit line. It will leak out of the
brake fluid reservoir.
● Be careful not to allow dusts or
water to go inside when it is
replenished.
● Don't use the unrecommended
brake fluid.
● Brake fluid can damage severely the
plastics or rubbers. When it is spilt
o n t h e p a r t s , w i p e t h e m u p
immediately.
5. Fasten the cap.
⊙ REAR BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the rear brake fluid reservior
around not to allow dust to get inside of it.
3. Turn the cap to the counter - clockwise.
4. Replenish with brake fluid to the upper
line.
N O T E
The recommended brake fluid : DOT4
5. Fasten the cap.
⊙ REAL BRAKE LAMP SWITCH
The rear brake lamp switch is located at
right-side of the engine.
Move the switch up or down to adjust it
until the switch operates and turns on the
brake lamp after the brake pedal begins to
be depressed.
77