Storage Procedure - HYOSUNG GD250 Owner's Manual

STORAGE PROCEDURE

If you don't plan on using your motorcycle
for a long time, it will need special servicing
requiring appropriate materials, equipment
and skill. For this reason, Hyosung
recommends that you trust this maintenance
work to your dealer. If you wish to service the
machine for storage yourself, follow the
general guidelines below :
★ MOTORCYCLE
Clean the entire motorcycle.
Place the motorcycle on a firm, flat
surface where it will not fall over.
Turn the handlebars all the way to the left
and lock the steering, and remove the
ignition key.
★ FUEL
Drain the fuel in the fuel tank.
★ BATTERY
1. Remove the battery from the motorcycle.
N O T E
Be sure to remove the negative terminal
first, then remove the positive terminal.
2. Clean the outside of the battery with mild
detergent and remove any corrosion from
the terminals and wiring harness
connections.
3. Store the battery in a room above
freezing.
★ TIRES
Inflate the tires to the normal pressure.
★ EXTERNAL
·· S pray all vinyl and rubber parts with
rubber protectant.
·· S pray the unpainted surfaces with rust
preventative.
·· C oat the painted surfaces with car wax.
★ MAINTENANCE DURING
STORAGE
Once a month, recharge the battery.
The 『
charging time is 1.0 A × 10 hours.
★ P ROCEDURE FOR
RETURNING TO
SERVICE
1. Clean the entire motorcycle.
2. Drain the engine oil, and replace the
engine oil filter & engine oil with a new
one.
3. Reinstall the battery.
N O T E
Be sure connect the positive terminal
first, then connect the negative terminal.
4. Adjust the pressure of tires as described
in the TIRE section.
5. Remove the spark plug and push
several times the electric starter switch
to start the engine.
Reinstall the spark plug.
6. Lubricate all places as instructed in this
manual.
7. Perform the INSPECTION BEFORE
RIDING as listed in this manual.
90
』's battery standard