HYOSUNG GD250 Owner's Manual page 49

When the ignition switch is set to "ON"
position with the engine stopped, the meter
lamp will come on and the segments of the
tachometer will turn on once to the end as
a test of electric system operation.
Push the starter switch after all the
segments of the tachometer turn off.
CAUTION
Do not attempt the start the engine until
all the segments of the tachometer turn
on and then turn off again otherwise
the engine will start badly.
If the engine does not start or runs
badly, turn the ignition switch to the
"OFF" position. After 8 seconds, turn
the ignition switch on, allow all the
segments of the tachometer turn on
and turn off again and then attempt to
restart.
This allows the ISC (Idling Speed
Control) solenoid to be initialized.
CAUTION
If the "FI" check lamp does not come
on when the ignition switch is set to
"ON" position with the engine stopped
or fail to go out after the engine start,
contact an authorized Hyosung dealer.
The "FI" check lamp
remains lit when the ignition switch is
set to "ON" position with the engine
stopped as a test of injection system
operation.
As soon as the engine starts, the "FI"
①
check lamp
If the fuel injection system fails, the "FI"
①
check lamp
lit.
Riding the motorcycle with the "FI"
check lamp lit after starting the engine
c a n d a m a g e t h e e n g i n e a n d
transmission.
Whenever the "FI" check lamp is lit
while riding the motorcycle, have your
authorized Hyosung dealer or a
qualified mechanic inspect the electric
fuel injection system as soon as
possible.
48
CAUTION
①
comes on and
should go out.
comes on and remains