HYOSUNG GD250 Owner's Manual page 46

CAUTION
Failure to use the correct oil can
damage your motorcycle.
Engine damage may occur if you use
the engine oil that does not meet
Hyosung's specifications.
Be sure to use the engine oil specified
in the FUEL, ENGINE OIL AND ENGINE
COOLANT RECOMMENDATION
section.
11. Install the engine oil filler plug ①·.
12. Start the engine and allow it idle for a
few minutes. Check to see that no the
engine oil is leaking from the engine oil
filter ③ and engine oil drain plug ②·.
13. Check the engine oil level according to
Engine Oil Level Check procedure.
CAUTION
Engine oil leaks from around the engine
oil filter or drain plug indicate incorrect
installation or the gasket damage. If you
find any leaks or are not sure that the
engine oil filter / drain plug has been
properly installed, have the motorcycle
inspected by your Hyosung dealer or
qualified mechanic.
ENGINE COOLANT
⊙ COOLANT LEVEL
The coolant should be kept between the
"F"(FULL) and "L"(LOW) level lines in the
reservoir tank at all times.
Inspect the level every time before riding
while the motorcycle vertically. If the
coolant is found lower than the "L" level
line, add properly mixed coolant in the
following way :
If the reservoir tank is emptied, pour the
engine coolant to the reservoir tank and
radiator.
Wait for the engine to cool down before
checking or topping up coolant level.
N O T E
Position the motorcycle on firm and flat
ground.
45
WARNING