Troubleshooting - HYOSUNG GD250 Owner's Manual

TROUBLESHOOTING

This troubleshooting guide is provided to
help you find the cause of some common
complaints.
CAUTION
Failure to troubleshoot a problem
correctly can damage your motorcycle.
Improper repairs or adjustments may
damage the motorcycle instead of
fixing it. Such damage may not be
covered under warranty.
If you are not sure about the proper
action, consult your Hyosung dealer
about the problem.
★ W HEN THE ENGINE
REFUSES TO START
⊙ IGNITION SYSTEM CHECK
1. Remove the spark plug and reattach it to
the spark plug lead.
2. Put the engine stop switch in the "
position and the ignition switch in the
"ON" position. Holding the spark plug
base firmly against the engine, the
transmission in neutral, the side stand
up, the clutch disengaged and push the
electric starter switch.
If the ignition system is operating
properly, a blue spark should jump
across the spark plug gap.
When the ignition switch is set to "ON"
position with the engine stopped, the
meter lamp will come on and the
segments of the tachometer will turn on
once to the end as a test of electric
system operation.
Push the starter switch after all the
segments of the tachometer turn off.
3. If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug or
new one.
85
"