HYOSUNG GD250 Owner's Manual page 67

To remove the air cleaner element :
1. Remove the front center cover ①.
❶
2. Remove the four screws ②
3. Pull up the air cleaner element
❷
·.
③·.
❷
❸
66
4. Clean the air cleaner element for the
following :
1) When the air cleaner element clean
with the air gun, necessarily blow at
the inside by compressed air.
2) Carefully examine the air cleaner
element for tears during cleaning.
Replace it with a new one if it is torn.
3) Assemble the element completely or
damage severely the engine.
4) Be careful not to allow water to go
inside the air cleaner element.
CAUTION
Before and during the cleaning
operation, inspect the element for tears.
A torn element must be replaced.
Be sure to install the element snugly
and correctly, so that no incoming air
will bypass it.
Remember, rapid wear of the piston
rings and cylinder bore is often caused
by a defective or poorly fitted element.
CAUTION
● When the air cleaner element is not
installed correctly, dust can go
inside and severely damage the
engine.
● Be careful not to allow water to go
into the element while washing.
WARNING
Operating the engine without the air
cleaner element in place can be
hazardous.
Never run the engine without the air
cleaner element in place.