Bulbs - HYOSUNG GD250 Owner's Manual

BULBS

WARNING
Keep fuel and other flammable
substances away from electric
components.
CAUTION
Before changing a bulb, set the ignition
switch to position "OFF" and allow a
few minutes for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid
any damage.
DO NOT PULL ON THE WIRES.
N O T E
Before changing a bulb, check the
fuses.
⊙ INSPECTION OF LAMPS
● Check if the position lamp, meter lamp,
tail lamp and license plate lamp work
well when the ignition switch was turned
to the "ON" position.
Check if the head lamp work well when
starting the engine.
● Check if the brake lamp work well when
the front brak lever or rear brake pedal
was operated.
● Check if the turn signal lamp work well
when the turn signal switch was
operated.
● Check if the head lamp, tail lamp, turn
signal lamp and brake lamp are dusty or
damaged.
Turn signal lamp
Brake / Tail lamp
Turn signal lamp
81
Head lamp
&
Position
lamp
License
plate lamp