CAUTION
The position lamp, meter lamp, tail
lamp and license plate lamp on this
motorcycle always comes on when the
ignition switch is turned to the "ON"
position .
The head lamp is always lit when
starting the engine.
⊙ REPLACEMENT OF THE LAMP
Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than rules may
cause to excessive at the electric system
or to damage the lamp.
NAMES
HI/LO
Head lamp
Position
Brake / Tail lamp
Turn signal lamp
License plate lamp
※ LED : Light Emitting Diode
CAUTION
Using a lamp bulb with the wrong
wattage rating can cause electrical
system damage or shorten bulb life.
Always use the specified lamp bulb.
CAPACITY
12V - H4 : 60/55W × 1
12V - W5W × 1
LED type
12V - RY10W × 4
12V - W5W·× 1
⊙ H EAD LAMP'S BULB
REPLACEMENT
1. Remove the two bolts
and the head lamp assembly.
❶
2. Remove the dust cover
3. Disconnect the head lamp coupler.
4. Remove the bulb socket spring ③ by
pressing it.
5. After removing the bulb
replace the new bulb.
❹
6. To reinstall the head lamp, reverse the
above sequence.
82
①·
(right and left)
②
.
at the socket,
④
❸
❷