Addressing The 6160 Keypad; Addressing The 6160 Keyprox; Addressing The 6160 Rfh - Honeywell Galaxy 2 Series Installation Manual

6160 Keypad (cont'd)

Addressing the 6160 Keypad

Keypad address (CON ADDR) needs to be from 0 to 3.
To set the address:
1. Either repower the keypad or activate the keypad tamper switch.
2. Within 60 seconds of step 1, press and hold buttons 1 and 3 for five seconds.
NOTE: If 10 seconds pass without a key entry, the keypad exits address mode. You must power down,
power up and start the procedure again.
3. The current keypad address will be displayed.
4. Type address of keypad (00, 01, 02, 03) then press
5. Remove then re-apply power to the system, including the keypad, to allow the new address to configure.

Addressing the 6160 Keyprox

The reader module shares the ECP Bus terminals with the keypad. The system will see the reader as an RF
receiver (address 4 or 5). The addressing can be achieved by using the address Jumper Link that is located
above the ECP terminals. These jumpers must be set before powering up the unit.
Jumper Link not fitted: Address = 4
Jumper Link fitted:
NOTE: A keyprox unit cannot be fitted if that address is already used by any wireless receiver.
The keypad section of the keyprox should be addressed as per the keypad instructions above.

Addressing the 6160 RFH

1. Enter the program mode by pressing the 1 and 3 keys simultaneously for a few seconds, within 60 sec-
onds after applying power. The display shows CON ADDR = XX.
2. Enter the 2-digit keypad address (00 - 03).The display shows CON ADDR = YY. Press the * key to
continue.
3. To enable the receiver - enter 1 to enable or 0 to disable. Enable the receiver if RF transmitters or wire-
less keypads are programmed into the control and no other receivers are enabled. The display shows
REC ON. Press the * key to continue.
4. If receiver is enabled, enter the 2-digit receiver address (04 or 05). The display shows
REC ADDRESS = XX. Press the * key to continue.
5. Enable High Security Mode by pressing the 1 key. The display shows HIGH SECURITY ON.
Press the * key to continue.
NOTE: If this mode is enabled, the 6160RFH will only recognise encrypted fobs. If this mode is
disabled, the 6160RFH will recognise both encrypted and non-encrypted fobs.
6. Press the * key. This exits program mode.
7. Remove then re-apply power to the system, including the keypad, to allow the new addresses to config-
ure.
Address = 5
Galaxy 2 Series Installation Manual
to save address and exit menu.
36