Outputs; Trigger Header; Trig 1-8 - Honeywell Galaxy 2 Series Installation Manual

Output Addresses

Outputs

The Galaxy 2 Series has four on-board outputs; Bells, Strobe, Speaker and Set. The format of the address-
ing of the outputs is similar to zones. The addresses of these outputs are as follows:
Output
Address
1001
1002
1003
1004
*NOTE: Output 1002 - This output is configured as a 16 Ohm speaker driver (AC signal). The speaker
should be connected between this output and +12V. The speaker Entry/Exit volume is controlled
by parameter 51.10. It is possible to reprogram the output to operate as a normal switched
negative output by programming parameter 51.15 to 0=Switch DC. However, when it is repro
grammed to operate as Switch DC, a loudspeaker should never be connected directly to this
terminal otherwise damage may result. Always ensure that this parameter is set to 1=Speaker
Driver, before connecting a loudspeaker.

Trigger Header

The Trigger Header on the Galaxy 2 Series is a set of pins, which consists of programmable outputs for an
external communication module. The connection is via an optional ribbon cable (Part No. A229).

Trig 1-8

There are eight trigger outputs, which are intended as communication triggers, but can be used for any pur-
pose. By default these outputs are programmed as positive. They are designed to sink current (to 0V) not
source current (from 12V). The addresses of these outputs are as follows:
The function of the trigger outputs can be programmed in menu 53=Outputs.
Default
function
Set
*
Not Used
Bell
Strobe
Table 3. Output Addresses
Output Default
Address function
0001 Fire
0002 Panic
0003 Intruder
0004 Set
0005 Omit
0006 Not Used
0007 Confirm
0008 Not Used
Table 4. Trigger Output Addresses
Galaxy 2 Series Installation Manual
Current (mA) Normal State
100 Off
- -
100 Off
100 Off
Current (mA)
100
100
100
100
100
100
100
100
16
Active State
0V
-
0V
0V