Honeywell Galaxy 2 Series Installation Manual page 71

Galaxy 2 Series Installation Manual
Keypad tamper lockout is indicated on the keypad display. After 20 attempts, a tamper is logged and an event
is signalled. When option 2 or 3 are selected the same rules apply to wireless fobs and prox tags.
15 = SPK Mode
This function selects whether the LS (loudspeaker) terminal acts as a speaker driver or a normal switched
output. There are two settings.
0. Switch DC
1. SPK Driver
NOTE: Never connect a land speaker to this terminal when the mode is set to Switch DC.
16 = Master Code
This parameter selects if access authorization is required. There are two settings:
1. Always authorized
2. Temp authorized
This setting operates via Option 48 = Level 3 access.
17 = Restart
This parameter has two sub-options:
1. Restart
The Restart option configures any modules that have been added to the system but gives an alarm if there are
any tampers open or if any modules are reported as missing. The message WARNING!!! ent = RESTART
SYS. is displayed. Press the ent key to restart the system.
2. Load Defaults
This parameter re-configures the system without the need to remove and reconnect the power. The system
displays a WARNING!!! ent=DEFAULT, press the ent key to reconfigure the system. The keypad display
becomes blank for a few seconds, then displays the message Loading Defaults. When configuration is
complete the banner returns to the normal display (day mode).
NOTE: This parameter exits engineer mode.
NOTE: Outputs are momentarily reset during the restart. If the system has a communications requirement,
put it on test before using the restart.
18 = Stop Set
This parameter has four sub-options. Each is stop set Yes/No
0 = No – System can be set with condition present.
1 = Yes – Condition must be cleared before setting.
1. AC Fail
This option prevents setting of the system if there is a mains fail condition.
2. Batt Fault
This option prevents setting of the system if there is a low battery condition.
51 - Parameters (cont'd)
63