Remote Servicing
SECTION 10: REMOTE SERVICING
The Galaxy 2 Series control panel can be remotely and/or locally serviced by a Personal computer (PC). This
is accomplished when the Remote Servicing Pack is installed on the PC. Remote servicing is controlled in
menu options 56.1 and 56.5.
Telephone Line Set-Up
The control panel has an on-board modem. This allows remote servicing of the control panel without the need
for a separate comms module.
Alternatively, the GSM Module can be used for remote servicing when a land line is not available.
Direct Wire Set-Up
Alternatively, the PC can be connected directly to a single Galaxy 2 Series control panel, via the Program
Header and used to locally service the site. A special lead (part number ???) is required.
Remote Programming
All programming with this software can be done remotely from a PC. The following functions can also be
carried out:
•
the panel can operate with all user functions.
•
the event log can be viewed.
•
routine remote inspection can be carried out. Some diagnostic information can be uploaded from the
control panel to the PC to allow remote site servicing.
Galaxy 2 Series Installation Manual
98