Lan Statistics - ZyXEL Communications PMG5318-B20B User Manual

Figure 7 WAN Info
Table 3 WAN Info
LABEL
Interface
Description
Type
VlanMuxID
IPv6
Igmp Pxy
Igmp Src Enbl
MLD Pxy
MLD Src Enbl
NAT
Firewall
Status
IPv4 Address
IPv6 Address

3.3 LAN Statistics

Click Device Info > Statistics > LAN to open this screen of traffic statistics counters for the
GPON Device's wired and wireless LAN interfaces. Use the button to clear the counters.
Chapter 3 Device Info
DESCRIPTION
This shows the name of the WAN interface. veip0 stands for a virtual Ethernet card and is
the foundation for veip0/* which are virtual WAN interfaces of the physical GPON line. The
ppp0.* indicates a PPP connection.
The number after the dot (.) represents the VLAN ID number assigned to traffic sent
through this connection. The number after the underscore (_) represents the index number
of connections through the same interface.
(null) means the entry is not valid.
This is the service name of this connection.
This shows the method of encapsulation used by this connection (IP over Ethernet, PPP over
Ethernet, or bridging).
This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
This displays whether or not IPv6 is enabled on the interface.
This shows whether IGMP (Internet Group Multicast Protocol) proxy is activated or not for
this connection. IGMP is not available when the connection uses the bridging service.
This shows whether IGMP source enable is activated or not for this connection. IGMP source
enable has the GPON Device add routing table entries based on the IGMP traffic.
This shows whether Multicast Listener Discovery (MLD) proxy is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
This shows whether MLD source enable is activated or not for this connection. MLD source
enable has the GPON Device add routing table entries based on the MLD traffic.
This shows whether NAT is activated or not for this interface. NAT is not available when the
connection uses the bridging service.
This shows whether the firewall is activated or not for this interface.
This displays the connection state or Unconfigured if the interface has not yet been
configured.
This displays the interface's current IPv4 address if it has one.
This displays the interface's current IPv6 address if it has one.
PMG5318-B20B User's Guide
16