Arp Info - ZyXEL Communications PMG5318-B20B User Manual

Figure 10 Route Info
Table 6 Route Info
LABEL
Destination
Gateway
Subnet Mask
Flag
Metric
Service
Interface

3.6 ARP Info

Click Device Info > ARP to display the GPON Device's IPv4 Address Resolution Protocol and IPv6
neighbor tables. This screen lists the IP addresses the GPON Device has mapped to MAC addresses.
Figure 11 ARP Info
Table 7 ARP Info
LABEL
IP address
Flags
HW Address
Device
Chapter 3 Device Info
DESCRIPTION
This displays the IP address to which this entry applies.
This displays the gateway the GPON Device uses to send traffic to the entry's destination
address.
This displays the subnet mask of the destination net.
This displays whether the route is up (U), the GPON Device drops packets for this
destination (!), the route uses a gateway (G), the target is in the neighbor cache (C), the
target is a host (H), reinstate route for dynamic routing (R), the route was dynamically
installed by redirect (D), or modified from redirect (M).
The metric represents the "cost" of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly-connected networks.
The name of a specific service to which the route applies if one is specified.
The interface through which this route sends traffic.
DESCRIPTION
The learned IP address of a device connected to one of the system's ports.
Static - static entry, Dynamic - dynamic entry that is not yet complete, Complete -
dynamic entry that is complete.
The MAC address of the device with the listed IP address.
The interface through which the GPON Device sends traffic to the device listed in the entry.
PMG5318-B20B User's Guide
19