Add Policy Routing; Rip - ZyXEL Communications PMG5318-B20B User Manual

9.3.1 Add Policy Routing

Click Add in the Policy Routing screen to open the following screen. Use this screen to configure
the required information for a policy route.
Figure 46 Policy Routing: Add
Table 42 Policy Routing: Add
LABEL
Policy Name
Physical LAN Port
Source IP
Use Interface
Default Gateway
IP
Apply/Save

9.4 RIP

Click Advanced Setup > Routing > RIP to open the RIP screen. Use this screen to configure RIP
settings. Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange
routing information with other routers.
Chapter 9 Routing
DESCRIPTION
Enter a descriptive name of printable English keyboard characters, not including spaces.
Select the source LAN Ethernet port number.
Enter the source IP address.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Enter the default gateway IP address the route uses.
Click this button to save your changes.
PMG5318-B20B User's Guide
60