Restoring Factory Defaults - ZyXEL Communications PMG5318-B20B User Manual

Table 78 Settings: Update
LABEL
Settings File Name
Browse...
Update Settings
Do not turn off the GPON Device while configuration file upload is in
progress
You must then wait before logging into the GPON Device again. The GPON Device automatically
restarts causing a temporary network disconnect. In some operating systems, you may see the
following icon on your desktop.
Figure 89 Temporarily Disconnected
You may need to change the IP address of your computer to be in the same subnet as that of the
GPON Device's IP address (192.168.1.1). See the appendix for details on how to set up your
computer's IP address.

22.3 Restoring Factory Defaults

Click Management > Settings > Restore Default to open the following screen.
Figure 90 Management > Settings > Restore Default
Click Restore Default Settings to clear all user-entered configuration information and return the
GPON Device to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your GPON
Device.
You may need to change the IP address of your computer to be in the same subnet as that of the
default GPON Device IP address (192.168.1.1). See the appendix for details on how to set up your
computer's IP address.
Chapter 22 Settings
DESCRIPTION
Type in the location of the file you want to upload in this field or click Browse... to find
it.
Click Browse... to find the file you want to upload. Remember that you must
decompress compressed (.ZIP) files before you can upload them.
Click this to begin the upload process.
PMG5318-B20B User's Guide
111