Fan Replacement - Regency PG33-NG Owners & Installation

1) Shut off the power supply.
2) Remove the top louvre.
3) Remove the glass door.
4) Remove the 3 screws which secure the manual control box to the
bottom louvre and remove the bottom louvre.
5) Unplug the 6 pin Molex connector and carefully pull out the ECS
box.
6 Pin Molex
Connector
6) Remove the electric cover by undoing the 2 screws, pull out the
grommet and the harness.
Electric Cover
Regency PG33 Gas Inbuilt

FAN REPLACEMENT

Manual Con-
trol Box
ECS Box
7) Unplug the black wire from the resister.
8) Carefully slide the fan to the front left side of the unit.
9) Remove the screw which holds the ground wire and disconnect all
electrical connectors that are attached to the fan.
10) Pull out the fan.
11) Reverse steps to install new fan.
MAINTENANCE
Ground Wire
35