Exterior Flue Termination Locations - Regency PG33-NG Owners & Installation

Hide thumbs

Table Of Contents

Table of Contents

INSTALLATION

according to AS5601-2004 (AGA gas installation code) or NZS 5261 (New Zealand)

Clearance (mm)

Below eaves, balconies or other projections:

- Appliances up to 50 MJ/h input

- Appliances over 50 MJ/h input

From the ground or above a balcony

From a return wall or external corner

From a gas meter (M)

From an electricity meter or fuse box (P)

From a drain or soil pipe

Horizontal from any building structure (unless appliance is approved

for closer installation) or obstruction facing a terminal

From any other flue terminal, cowl or combustion air intake

Horizontally from an openable window, door, or non-mechanical air inlet, or

any other opening into a building, with the exception of sub-floor ventilation

(see also Note (I)):

- Appliances up to 150 MJ/h input

- Appliances over 150 MJ/h input

Vertically below an openable window, door, or non-mechanical air inlet,

or any other opening into a building, with the exception of sub-floor ventilation

(see also Note (I)): see table below

Up to 50 MJ/h input

NOTES:

(I) For mechanical air inlets, including spa blowers, the clearance 'j' and 'k' shall be 1500 mm in all cases.

(II) All distances shall be measured vertically or horizontally along the wall to a point in line with the nearest par

to of the terminal.

(III) Prohibited area below electricity meter or fuse box extends to ground level.

(IV) A flue terminal of this type shall not be located under a roofed area unless the roofed area is fully open on

at least two sides and a free flow of air at the appliance is achieved.