Table of Contents
Advertisement
REMOTE CONTROL
Use the Regency Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter and a wall mounting plate.
1) Choose a convenient location to mount the
hand held transmitter, protection from
extreme heat is very important.
The remote can also be used as a wall
thermostat.
LIGHTING
INSTRUCTIONS
1) Plug the power cord into a power outlet.
2) Press and release the ON/OFF button once to
start the unit.
3) After approximately 3 seconds the spark igni-
tion system will spark for 40 seconds to light
the main burner.
4) If the main burner does not light, reset the unit.
RESETTING
THE UNIT
1) Open the bottom louvre of the unit.
2) Press the reset button for approximately 3
seconds. It is located on the unit's control panel
once.
3) Wait for approximately 3 seconds and the pilot
sparks can be heard and seen. It would take 2
to 3 seconds for the flame to be lit.
Regency PG33 Gas Inbuilt
SHUTDOWN
INSTRUCTIONS
1) Press the ON/OFF button once.
2) Turn off all electric power to the appliance if
service is to be performed.
FIRST FIRE
The FIRST FIRE in your heater is part of the paint
curing process. To ensure that the paint is properly
cured, it is recommended that you burn your fireplace
for at least four (4) hours the first time you use it
with the fan on.
When first operated, the unit will release an odour
caused by the curing of the paint and the burning
off of any oils remaining from manufacturing. Smoke
detectors in the house may go off at this time. Open
a few windows to ventilate the room for a couple of
hours. The glass may require cleaning.
NOTE: The main burner will always start on "HIGH"
and resume it's last setting after 20 seconds
of operation.
NOTE: When the glass is cold and the appliance
is lit, it may cause condensation and fog
the glass. This condensation is normal and
will disappear in a few minutes as the glass
heats up.
DO NOT ATTEMPT TO CLEAN THE GLASS
WHILE IT IS STILL HOT!
DO NOT BURN THE APPLIANCE WITHOUT
THE GLASS FRONT IN PLACE.
During the first few fires, a white film
may develop on the glass front as part
of the curing process. The glass should
be cleaned or the film will bake on and
become very difficult to remove. Use a
non-abrasive cleaner and NEVER clean
the glass while it is hot.
OPERATING INSTRUCTIONS
INSTALLATION
OPERATING
INSTRUCTIONS
Before operating this appliance, proceed through
the following check list.
1) Read and understand these Instructions before
operating this appliance.
2) Check to see that all wiring is correct and en-
closed to prevent possible shock.
3) Check to ensure there are no gas leaks.
4) Make sure the three pieces of door glass are
properly positioned. Never operate the appli-
ance with any of the glass removed or with the
door open.
5) Verify that all flueing and the cap is unobstructed.
6) Verify log placement.
31
31
Advertisement
Table of Contents
