Configure Eth0 Dhcp Range - IBM p5 590 System Handbook

If the managed system is unable to contact the HMC DHCP service, then the
managed system will use its last given IP address.
If this is the first (or only) HMC connected to the managed servers, select the
192.168.0.2 - 192.168.255.254 range and click Next to continue. If this is the
secondary (or redundant) HMC connected to the same p5-590 or p5-595
servers, then you must select a range of addresses which is different from the
range which was selected on the first HMC.
Figure 8-14 Configure eth0 DHCP range
If you select YES, you will be asked to configure the next adapter, with NO you
are sent to the next configuration point, the HMC host name and domain. If you
configure a second LAN adapter, you must also configure a firewall. This will be
discussed later on. For this example, select NO (Figure 8-15).
217
Chapter 8. Hardware Management Console overview