Furuno FMD-3200 Operator's Manual page 174

10. USER CHARTS
(2) Click
(1) Click
How to create a line
(4) Right-click;
select Finish.
How to create an area
6. When you insert an object, the following is done in the [User Chart] dialog box:
- Name of the object button appears in the [Object] window
- Latitude and longitude position of the object is displayed
- Total object count is updated
7. To enter a name for the object, click the appropriate location in the [Name] window
then use the software keyboard or the Control Unit to enter a name.
Note: The name entered for circles and areas can be shown inside the area or
circle on the screen. For details, see paragraph 4.3.4.
8. To show the object on the radar overlay, click the corresponding box in the [Radar]
window to show a checkmark in the box.
For the label, line, clearing line, area and circle, click the corresponding box in
the [Danger] window to use or don't use the object in chart alert calculation. Show
a red checkmark to use the object in chart alert calculation.
For an area, circle, line, you can add Notes as shown below. See the description
and figure below for a description of Notes.
1) Enter the text for the Notes in the [Description] box.
2) Click the box in the [Notes] window of the [User Chart] dialog box to set the
message display method.
• E: Message appears when your ship approaches the user chart object. For
• P: Message appears when your ship is 10NM beyond the user chart object
• Blank: No message display.
10-4
(3) Click
(4) Right-click;
select Finish.
(1) Click
(2) Click
(3) Click
a line, message appears when you are "x" miles from the line, which is set
with [Range of notes].
object.
(1) Click
(2) Drag cursor;
double-click
to set.
1) Put cursor where to locate center of circle
then click.
2) Drag cursor to set radius; double-click to set.
How to create a circle