HP 9304m Installation And Getting Started Manual page 92

HP9300# clock set 10:15:05 10-15-99
Syntax: [no] clock set <hh:mm:ss> <mm-dd-yy> | <mm-dd-yyyy>
By default, HP switches and routers do not change the system time for daylight savings time. To enable daylight
savings time, enter the following command:
HP9300# clock summer-time
Syntax: clock summer-time
Although SNTP servers typically deliver the time and date in Greenwich Mean Time (GMT), you can configure the
Routing Switch to adjust the time for any one-hour offset from GMT or for one of the following U.S. time zones:
• US Pacific (default)
• Alaska
• Aleutian
• Arizona
• Central
• East-Indiana
• Eastern
• Hawaii
• Michigan
• Mountain
• Pacific
• Samoa
The default is US Pacific.
To change the time zone to Australian East Coast time (which is normally 10 hours ahead of GMT), enter the
following command:
HP9300(config)# clock timezone gmt+10
Syntax: clock timezone gmt | us <time-zone>
You can enter one of the following values for <time-zone>:
• US time zones (us): alaska, aleutian, arizona, central, east-indiana, eastern, hawaii, michigan, mountain,
pacific, samoa.
• GMT time zones (gmt): gmt+12, gmt+11, gmt+10...gmt+01, gmt+00, gmt-01...gmt-10, gmt-11, gmt-12.
USING THE WEB MANAGEMENT INTERFACE
To set the local time for the system:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select the Clock link to display the Clock panel, shown below.
Configuring Basic Features
4 - 13