HP 9304m Installation And Getting Started Manual page 156

Table 5.5: CLI Display of Link Aggregation Information (Continued)
This Field...
Sys P
Port P
Key
Act
Tio
Agg
Syn
Col
Configuring Trunk Groups and Dynamic Link Aggregation
Displays...
Lists the system priority configured for this port.
Lists the port's link aggregation priority.
Lists the link aggregation key.
Indicates the link aggregation mode, which can be one of the
following:
• No – The mode is passive or link aggregation is disabled (off) on
the port.
If link aggregation is enabled (and the mode is passive), the port
can send and receive LACPDU messages to participate in
negotiation of an aggregate link initiated by another port, but
cannot search for a link aggregation port or initiate negotiation of
an aggregate link.
• Yes – The mode is active. The port can send and receive
LACPDU messages.
Indicates the timeout value of the port. The timeout value can be one
of the following:
• L – Long. The trunk group has already been formed and the port
is therefore using a longer message timeout for the LACPDU
messages exchanged with the remote port. Typically, these
messages are used as confirmation of the health of the
aggregate link.
• S – Short. The port has just started the LACPDU message
exchange process with the port at the other end of the link. The S
timeout value also can mean that the link aggregation information
received from the remote port has expired and the ports are
starting a new information exchange.
Indicates the link aggregation state of the port. The state can be one
of the following:
• Agg – Link aggregation is enabled on the port.
• No – Link aggregation is disabled on the port.
Indicates the synchronization state of the port. The state can be one
of the following:
• No – The port is out of sync with the remote port. The port does
not understand the status of the LACPDU process and is not
prepared to enter a trunk link.
• Syn – The port is in sync with the remote port. The port
understands the status of the LACPDU message exchange
process, and therefore knows the trunk group to which it belongs,
the link aggregation state of the remote port, and so on.
Indicates the collection state of the port, which determines whether
the port is ready to send traffic over the trunk link.
• Col – The port is ready to send traffic over the trunk link.
• No – The port is not ready to send traffic over the trunk link.
5 - 25