Displaying Gvrp Information; Displaying Gvrp Configuration Information - HP 9304m Installation And Getting Started Manual

NOTE: After you convert the VLAN, the VLAN name changes from "'GVRP_VLAN_<vlan-id>" to
"STATIC_VLAN_<vlan-id>".

Displaying GVRP Information

You can display the following GVRP information:
• GVRP configuration information
• GVRP VLAN information
• GVRP statistics

Displaying GVRP Configuration Information

To display GVRP configuration information, enter a command such as the following:
HP9300(config)# show gvrp
GVRP is enabled on the system
GVRP BASE VLAN ID
GVRP MAX Leaveall Timer
GVRP Join Timer
GVRP Leave Timer
GVRP Leave-all Timer
===========================================================================
Configuration that is being used:
block-learning ethe 1/3
block-applicant ethe 2/7 ethe 2/11
enable ethe 1/1 to 1/7 ethe 2/1 ethe 2/7 ethe 2/11
===========================================================================
Spanning Tree: SINGLE SPANNING TREE
Dropped Packets Count: 0
===========================================================================
Number of VLANs in the GVRP Database: 15
Maximum Number of VLANs that can be present: 4095
===========================================================================
Syntax: show gvrp [ethernet <port-num>]
Configuring GARP VLAN Registration Protocol (GVRP)
: 4093
: 300000 ms
: 200 ms
: 600 ms
: 10000 ms
8 - 9