HP 9304m Installation And Getting Started Manual page 166

This Field...
Root Port
Priority Hex
Max age sec
Hello sec
Hold sec
Fwd dly sec
Last Chang sec
Chg cnt
Bridge Address
Port STP Parameters
VLAN ID
Port Num
Priority Hex
Path Cost
Table 6.4: CLI Display of STP Information (Continued)
Displays...
The port on this device that connects to the root bridge. If this device
is the root bridge, then the value is "Root" instead of a port number.
This device or VLAN's STP priority. The value is shown in
hexadecimal format.
Note: If you configure this value, specify it in decimal format. See
"Changing STP Bridge Parameters" on page 6-4.
The number of seconds this device or VLAN waits for a hello message
from the root bridge before deciding the root has become unavailable
and performing a reconvergence.
The interval between each configuration BPDU sent by the root
bridge.
The minimum number of seconds that must elapse between
transmissions of consecutive Configuration BPDUs on a port.
The number of seconds this device or VLAN waits following a topology
change and consequent reconvergence.
The number of seconds since the last time a topology change
occurred.
The number of times the topology has changed since this device was
reloaded.
The STP address of this device or VLAN.
Note: If this address is the same as the Root ID, then this device or
VLAN is the root bridge for its spanning tree.
The VLAN that the port is in.
The port number.
The port's STP priority, in hexadecimal format.
Note: If you configure this value, specify it in decimal format. See
"Changing STP Port Parameters" on page 6-6.
The port's STP path cost.
Configuring Spanning Tree Protocol (STP)
6 - 9