HP 9304m Installation And Getting Started Manual page 146

To display trunk group information for specific ports, enter a command such as the following:
HP9300(config)# show trunk ethernet 1/1 to 1/8
Configured trunks:
Trunk ID: 1
Type: Switch
Ports_Configured: 8
Primary Port Monitored: Jointly
Ports 1/1
Port Names none
Port_Status enable
Monitor on
Mirror Port 3/3
Monitor Dir both
Operational trunks:
Trunk ID: 1
Type: Switch
Duplex: Full
Speed: 1G
Tag: No
Priority: level0
Active Ports: 6
Ports 1/1
Link_Status active
Load Sharing
Mac Address 3
IP 0
IPX 0
Apple Talk 1
Multicast 4
The display is divided into sections for configured trunks and operational trunks. A configured trunk group is one
that has not been activated yet.
Table 5.3 describes the information displayed by the show trunk command.
This Field...
Trunk ID
Type
Configuring Trunk Groups and Dynamic Link Aggregation
1/2 1/3 1/4
none none none
enable enable enable
on off on
3/4 N/A 3/5
in N/A out
1/2 1/3
active active
2 2
0 0
2 1
2 0
2 5
Table 5.3: CLI Trunk Group Information
Displays...
The trunk group number. The software numbers the groups in the
display to make the display easy to use.
The type of trunk group, which can be one of the following:
• Server – The trunk group is connected to a server.
• Switch – The trunk group is connected to another Routing Switch.
1/5 1/6
none longna
disable disable
off off
N/A N/A
N/A N/A
1/4 1/5 1/6
active down down
2 0 0
0 0 0
0 0 0
4 0 0
2 0 0
1/7 1/8
test none
enable enable
off off
N/A N/A
N/A N/A
1/7 1/8
active active
6 1
0 0
0 1
0 3
2 3
5 - 15