HP 9304m Installation And Getting Started Manual page 324

Message Level Message
Notification OSPF intf rcvd bad pkt: Invalid packet size,
rid <ip-addr>, intf addr <ip-addr>, pkt size
<num>, checksum <num>, pkt src addr <ip-
addr>, pkt type <type>
Notification SRP intf state changed, intf <portnum>, addr
<ip-addr>, state <srp-state>
Notification VRRP intf state changed,
intf <portnum>, vrid <virtual-router-id>,
state <vrrp-state>
Notification BGP Peer <ip-addr> UP (ESTABLISHED)
Notification BGP Peer <ip-addr> DOWN (IDLE)
Table A.2: HP Syslog Messages (Continued)
Explanation
The device received an OSPF packet with an
invalid packet size.
The parameters are the same as for the Bad
Checksum message.
A state change has occurred in an HP
Standby Router Protocol (SRP) interface.
The <portnum> is the port.
The <ip-addr> is the IP address of the SRP
interface.
The <srp-state> can be one of the following:
• init
• negotiating
• standby
• active
• unknown
A state change has occurred in a Virtual
Router Redundancy Protocol (VRRP)
interface.
The <portnum> is the port.
The <virtual-router-id> is the virtual router ID
(VRID) configured on the interface.
The <vrrp-state> can be one of the following:
• init
• master
• backup
• unknown
Indicates that a BGP4 neighbor has come
up.
The <ip-addr> is the IP address of the
neighbor's BGP4 interface with the HP
device.
Indicates that a BGP4 neighbor has gone
down.
The <ip-addr> is the IP address of the
neighbor's BGP4 interface with the HP
device.
Using Syslog
A - 27