HP 9304m Installation And Getting Started Manual page 121

Installation and Getting Started Guide
The tables you can configure as well the defaults and valid ranges for each table differ depending on the HP
device you are configuring.
NOTE: If you increase the number of sub-net addresses you can configure on each port to a higher amount, you
might also need to increase the total number of sub-nets that you can configure on the device.
To display and configure the adjustable tables on a device, use one of the following methods.
NOTE: Changing the table size for a parameter reconfigures the device's memory. Whenever you reconfigure
the memory on an HP device, you must save the change to the startup-config file, then reload the software to
place the change into effect.
USING THE CLI
To display the configurable tables and their defaults and maximum values, enter the following command at any
level of the CLI:
4 - 42