Displaying Neighbors - HP 9304m Installation And Getting Started Manual

Command Line Interface Reference

Displaying Neighbors

To display the Cisco neighbors the HP device has learned from CDP packets, enter the following command:
HP9300# show fdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
(*) indicates a Cisco device
Device ID
-------------- ------------ ------ ---------- ----------- -------------
(*)Router
FastEthernet5/0/0
Syntax: show fdp neighbors [detail | ethernet <portnum>]
To display detailed information for the neighbors, enter the following command:
HP9300# show fdp neighbors detail
Device ID: Router
Entry address(es):
IP address: 207.95.6.143
Platform: cisco RSP4,
Interface: Eth 1/1,
Holdtime : 150 seconds
Version :
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1,
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 19-Aug-99 04:12 by cmong
To display information about a neighbor attached to a specific port, enter a command such as the following:
HP9300# show fdp neighbors ethernet 1/1
Device ID: Router
Entry address(es):
IP address: 207.95.6.143
Platform: cisco RSP4,
Interface: Eth 1/1,
Holdtime : 127 seconds
Version :
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1,
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 19-Aug-99 04:12 by cmong
9 - 2
S - Switch, H - Host, I - IGMP, r - Repeater
Local Int Holdtm Capability Platform
Eth 1/1 124
Capabilities: Router
Port ID (outgoing port): FastEthernet5/0/0
Capabilities: Router
Port ID (outgoing port): FastEthernet5/0/0
R cisco RSP4
RELEASE SOFTWARE
RELEASE SOFTWARE
Port ID