Olivetti d-Color MF2001 Service Manual page 153

Code
Staple cover open
6023
DF top cover open
6043
DF paper conveying sensor
6103
non arrival jam
DF paper conveying sensor
6113
stay jam
DF paper conveying sensor
6123
remaining jam
DF eject paper sensor stay
6413
jam
DF eject paper sensor
6423
remaining jam
Front adjustment plate oper-
6803
ation ON error
Front adjustment plate oper-
6813
ation OFF error
Rear adjustment plate oper-
6903
ation ON error
Rear adjustment plate oper-
6913
ation OFF error
Staple operation error
7013
Staple initial operation error
7023
Sequence error 1
7913
(operation prohibited)
Sequence error 2
7923
(initialoperation error)
Sequence error 3
7933
(Error in the reception of
backup data)
Sequence error 4
7943
(standby)
Sequence error 5
7953
(Error in between copies)
*: Refer to figure 1-4-1 for paper jam location (see page 1-4-1).
Y113010-4
Contents
The staple cover is opened during operation.
The DF top cover is opened during operation.
The paper conveying sensor (PCS) does not
turned on even if a specified time has elapsed after
the machine eject signal was received.
The paper conveying sensor (PCS) does not turn
off within the specified time of its turning on.
The paper conveying sensor (PCS) does not
turned on when the power is turned on or the cover
is closed.
The eject paper sensor (EPS) does not turn off
within the specified time.
The eject paper sensor (EPS) does not turned on
when the power is turned on or the cover is closed.
The adjustment sensor 1 (ADS1) does turned on
when the job is executed.
The adjustment sensor 1 (ADS1) does not turned
off when the job is executed.
The adjustment sensor 2 (ADS2) does not turned
on when the job is executed.
The adjustment sensor 2 (ADS2) does not turned
off when the job is executed.
The next staple hasn't head-poked for the next
copy to bind after a predetermined interval while
clinching has commenced.
Head-poking has not been accomplished after 10
attempts in the initialization at power up or closing
the cover.
Operation commenced in the state the finisher is
prohibited to operate.
A request for maintenance mode has occurred in
the state the finisher is prohibited to operate or has
commenced operation.
A backup data command has been received in the
state the operation has initiated.
Operation has started in the state standby is pro-
hibited.
An illegal inter-page or inter-copy interval has
occurred.
Conditions
1-4-7
2KZ/2K0
Jam
location*
G
G
I
G
G
G
G
H
H
H
H
H
H
G
G
G
G
G
Sevice Manual