Changing The Name Of A Handset - Gigaset A540 IP Manual

Using multiple handsets
Internal call waiting during an internal/external call
If an internal party attempts to call you while you are involved in an external or
internal call, this call is shown on the display (internal call waiting). You can either
accept or reject this call.
Press any key to make this prompt disappear from the display.
You must end the current call to accept the internal call. Then the internal call is sig-
nalled as per usual. You can accept the call.
Setting up a conference call
You are conducting a call with an external participant and have set up an internal
conference call, or during an internal call you have accepted an external waiting
call.
You have the following options:
u
Swap between both participants:
¤
Use q to switch between the participants (call swapping).
u
Set up a conference call:
¤
Press the display key
u
Ending a conference call
¤
Press the
Or:
¤
If an internal participant presses the end call key a, the other handset
remains connected to the external participant.

Changing the name of a handset

The names "INT 1", "INT 2" etc. are assigned automatically on registration. You can
change these names. The name must be no longer than 10 characters. The changed
name is displayed in every handset's list.
u
s
§Menu§
Rename
~
§OK§
96
§Conf.§
§EndCon§
display key to return to call swap mode.
Open the list of handsets. Your own handset is indicated by <.
Select handset.
Open menu.
§OK§
Select and press .
Enter the name.
Press the display key.
to establish the conference call.