Fujitsu Primergy RX300 S4 User Manual page 240

Chapter 8 Operation and Maintenance
3
The following message is displayed at the bottom of the screen. Press the [F6]
key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
4
When a message prompting you to press the [F2] key appears under the
screen, press the [F2] key while the message is displayed.
A message prompting you to insert the Automated System Recovery floppy disk (created
beforehand) appears.
5
Insert the Automated System Recovery floppy disk and follow the window
instructions.
6
Install the driver.
Install the following driver according to the used array controller.
• When using the SAS RAID Ctrl (MegaRAID SAS):
LSI Logic MegaRAID SAS RAID Controller Driver
For the procedure for installing a driver, refer to the following "OS Installation Manually".
http://www.fujitsu.com/global/services/computing/server/ia/driver/
7
Follow the window instructions to restore the system.
• When replacing the floppy disk is required, replace it following the instructions.
• When the message that the driver doesn't pass the Windows logo test for verifying
interchangeability with Windows is displayed, select "Yes" and continue installing.
• When inserting media is required, insert the backup media (created beforehand) and perform
the process according to the message.
Notes on Automated System Recovery
Automated System Recovery does not restore data files.
240
Because this message is displayed for only a short time after the setup screen (blue
screen) is displayed, press the [F6] key immediately after the screen changes blue.