Fujitsu Primergy RX300 S4 User Manual page 228

Chapter 8 Operation and Maintenance
● When using Power Monitor
1
Start the Power Monitor from the ServerView S2.
2
Select the server for which you want to check the ServerView Remote
Connector service operation, from the left side frame.
3
Click the [Data] tab.
If the graph is displayed, the ServerView Remote Connector service is running normally. When
the service is not running normally, the following window appears.
Then, the following window appears.
228
1. Click [Start] – [Control Panel] – [Administrative Tools] – [Services] – [ServerView
Remote Connector].
2. Select [Restart Service] in the operation menu.
For the usage of Power Monitor, refer to "ServerView User's Guide".
When the ServerView Remote Connector service is not running normally, restart the service by
the following procedure below (There is no need to reboot the system).
1. Click [Start] – [Control Panel] – [Administrative Tools] – [Services] – [ServerView
Remote Connector].
2. Select [Restart Service] in the operation menu.