Chapter 6 Installing Internal Options; Before Installing Internal Options - Fujitsu Primergy RX300 S4 User Manual

Chapter 6 Installing Internal Options

6.1 Before Installing Internal Options

The following types of internal options can be installed on this server.
Internal hard disk unit
or internal backup device
When re-installing internal options, make sure to use the removed screws for the same device at the
same location where it was last installed. Failure to do so may damage the device.
For stable use of the server, use the devices described in the system configuration figure when adding
optional devices (internal/external options and USB devices etc.). Fujitsu does not warrant operation of
the server when using unauthorized third party optional devices.
The types of installable options described in this manual are subject to change without notice.
134
Expansion card
Internal hard disk unit
• Before installing/removing internal options to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also unplug
all power cables from the server. Failure to do so may cause electric shock
( "1.4.3 Turning Off the Server" (p.32).
When an array system is configured (RAID1, RAID1+0, RAID5, and RAID6),
internal hard disk units can be replaced without shutting down the server.
• Do not disassemble the PSU. Doing so may cause electric shock.
• Do not install unauthorized third party internal options.
Doing so may cause a device failure, fire, or electric shock.
• Do not damage or modify internal cables or devices.
Doing so may cause a device failure, fire, or electric shock.
Memory module
Power supply unit
CPU