Fujitsu Primergy RX300 S4 User Manual page 158

Chapter 6 Installing Internal Options
Installing/Removing SCSI Ctrl U320 lp (PG-2281L) or SAS RAID Ctrl (PG-
244CL, PG-248G2L)
Configuration information on the device changes by installing the SCSI Ctrl U320 lp (PG-2281L) or
SAS RAID Ctrl (PG-244CL) in the server because the bridge circuits are installed in the insides of the
cards.
Therefore, when adding/removing the SCSI Ctrl U320 lp (PG-2281L) after OS installation, the onboard
LAN controller might be recognized by the OS as a new device.
Perform the onboard LAN settings (IP address etc.) and set software that uses the onboard LAN again
after adding/removing the card.
SAS RAID Ctrl
A battery backup unit (BBU) is provided with the SAS RAID Ctrl (PG-248G2L, PG-248CL, and PG-
244CL). Make sure to install the battery backup unit.
"6.5.4 How to Install a Battery Backup Unit (BBU)" (p.161)
BIOS settings
Extended ROMs for the PCI slots 3 to 7 are disabled on this server. To perform the settings for the
expansion card to be installed, the extended ROM setting needs to be temporarily changed to "Enabled"
by the BIOS Setup Utility. The setting procedure is described below.
1
Enable the extended ROM for the slot where the target expansion card is
installed.
Start the BIOS Setup Utility and change the setting of [PCI Slot n Configuration Option ROM
Scan] (n is the slot number) in "
[Advanced] menu from "Disabled" to "Enabled".
2
Select [Save Changes & Exit] in "7.2.18 Exit Menu" ( p.208) to exit the BIOS
Setup Utility.
3
Perform expansion card settings by POST at restart.
For details about setting procedures, refer to the expansion card's manual.
4
Start the BIOS Setup Utility again and restore the setting changed in step 1.
Parallel port option/Serial port option
When installing parallel port option or serial port option, connect the cable to the baseboard after
installing it in the slot. For the connector location on the baseboard to connect the cable, refer to "1.3.4
Baseboard" ( p.28).
158
PCI SLOTS Configuration submenu" ( p.193) under the