Fujitsu Primergy RX300 S4 User Manual page 227

Warning Messages of ServerView Remote Connector
When ServerView Agent for Windows is installed, and the system is highly-loaded during startup, the
following warning message may be recorded on the Application Event Log at server startup.
Type: Warinig
Source: ServerView Remote Connector
Event ID: 0
Description: Initialization not completed timely (0 seconds)
A heavy load during system startup causes a delay in ServerView Remote Connector initialization
processing. This warning message reports that the service startup has not completed within the certain
period of time, and not that the service startup has failed.
In this case, ServerView Remote Connector service continues the initialization processing. The service
is automatically started after the completion of the initialization, so no special action is required.
The ServerView Remote Connector service is used with the following ServerView functions. Even if
this service is not active, no other functions are affected.
• Performance Manager
• Power Monitor
Follow either of the following procedures to check whether the ServerView Remote Connector service
is running normally.
When using Performance Manager
1
Start the Performance Manager from the ServerView S2.
2
Select the server for which you want to check the ServerView Remote
Connector service operation, from the left side frame.
3
Click the [Report View] tab.
4
Select any report, and click the [Show] button.
If the graph is displayed, the ServerView Remote Connector service is running normally. When
the service is not running normally, the following window appears.
It is necessary to perform report settings beforehand.
For the usage of Performance Manager, refer to "ServerView User's Guide".
When the ServerView Remote Connector service is not running normally, restart the service by
the following procedure below (There is no need to reboot the system).
PRIMERGY RX300 S4 User's Guide
227