Fujitsu Primergy RX300 S4 User Manual page 192

Chapter 7 Configuring Hardware and Utilities
Item
Parallel Mode
Parallel Address
USB Host Controller
USB 2.0 Host Controller
USB BIOS Supported
Devices
USB Boot Delay
USB BIOS Hot-Plug
USB Front
USB Rear
ATA Controller Config
Diskette Controller
Mouse Controller
Onboard Video
LAN Controller
LAN 1 Remote Boot
LAN 2 Remote Boot
ATA Controller Config submenu
Sets the Serial ATA.
Item
S_ATA Mode
Primary IDE Channel
Secondary IDE Channel
192
table: Items on the Peripheral Configuration Submenu
Setting
Bidirection (Unchangeable)
• 378h,IRQ7 (Initial
value)
• 278h,IRQ5
• 3Bch,IRQ7
Enabled (Unchangeable)
Enabled (Unchangeable)
Auto (Unchangeable)
0 s. (Unchangeable)
Enabled (Unchangeable)
• Disabled
• Enabled (Initial value)
• Disabled
• Enabled (Initial value)
Configures additional settings.
" ATA Controller Config submenu" (p.192)
Disabled (Unchangeable)
Auto Detect
(Unchangeable)
Enabled (Unchangeable)
LAN 1 & 2 (Unchangeable)
• Disabled (Initial value)
• PXE
• iSCSI
table: Items on the ATA Controller Config Submenu
Setting
Compatible
(Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
Description
Sets the data transfer mode of the parallel port.
Appears when [Enabled] or [Auto] is selected for
[Parallel].
Sets the parallel port address.
This item appears when [Enabled] is selected for
[Parallel].
Sets whether or not to use the USB controller (2.0
or 1.1 standard).
Sets which type of USB device should be used in
BIOS.
Sets the waiting time for booting from a USB
device.
Allows Hot-Plug of the USB device used for BIOS.
Sets whether or not to use the USB connector on the
front.
Sets whether or not to use the USB connector on the
back.
Sets whether or not to enable the floppy disk
controller.
Sets whether or not to use the mouse connected to
the mouse port.
Sets whether or not to enable the onboard video
controller.
Sets whether or not to enable the onboard LAN
controller (LAN 1, or LAN 1 & 2).
Sets whether or not to load the OS from the server.
This function is especially used when both floppy
disk drive and hard disk drive are not installed, or
both powers are turned off.
Description
Sets the Serial ATA mode.
Sets whether or not to enable the Primary IDE
Channel.
Sets whether or not to enable the secondary IDE
Channel.