[Job Reset]; [Stamp Settings] ([System Settings]) - Konica Minolta bizhub c554 User Manual

[Job Reset]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Reset Settings] - [Job Reset]
Select whether to reset settings for the conditions that are applied when changing users or loading a docu-
ment into the ADF.
Settings
[When Account is changed]
[When original is set on
ADF]
[Next Job]
[Default Basic/Enlarge Dis-
play Common Setting]

[Stamp Settings] ([System Settings])

To display: [Utility] - [Administrator Settings] - [System Settings] - [Stamp Settings]
Register header/footer programs and specify the stamp setting when sending a fax.
Settings
[Header/Footer Settings]
[Fax TX Settings]
bizhub C554/C454/C364/C284/C224
Description
Select whether to initialize all settings (except registered settings) when the
key counter or management card is removed.
[Reset] is specified by default.
Select whether to reset all settings (except registered settings) when doc-
ument is loaded into the ADF.
[Do Not Reset] is specified by default.
Select whether to reset Staple Setting, Original Set/Bind Direction settings,
and TX Settings for each job.
• [Staple Setting]: Select whether or not to take over the settings upon
completion of a job for which Staple has been specified.
[OFF] is specified by default.
• [Original Set/Bind Direction]: Select whether or not to take over the set-
tings upon completion of a job for which Original Set and Bind Direction
have been specified.
[OFF] is specified by default.
• [Reset Data After Job]: Select whether to clear all settings or only des-
tinations when resetting for each job in Scan/Fax TX Settings. If you se-
lect [Confirm with User], a confirmation screen appears to check with
you if settings or destinations are to be cleared.
[Reset All] is specified by default.
Select whether to configure the initial values for Normal and Enlarge Dis-
play mode at the same time.
If [Apply to all] is selected, [Default Enlarge Display Settings] does not ap-
pear. Initial values for each mode that are changed in [Default Copy Set-
tings] or [Default Scan/Fax Settings] are applied to both Normal and
Enlarge Display modes.
[Do not Apply] is specified by default.
Description
You can register header/footer programs, and change or delete registered
programs.
For details, refer to page 13-8.
Select whether to cancel stamp setting when sending a fax.
For details, refer to [User's Guide: Fax Operations].
13
13-7