Remove the gasket and dowel pin.
Remove the RH. crankcase cover oil seal.
Check the oil seal for wear or damage and replace with
a new one as necessary.
STARTER REDUCTION GEAR
REMOVAL
Remove the RH. crankcase cover.
Remove the startting clutch.
Remove the starter reduction gear and shaft.
INSPECTION
Check the reduction gear for wear or damage.
Measure the inner diameter of the gear.
SERVICE LIMIT : 9.08 mm
Measure the outer diameter of the gear shaft.
SERVICE LIMIT : 8.95 mm
A.C GENERATOR / STARTER CLUTCH
8-5